Banner Unisub® Sublimation Lid Topper

This listing is for a Single Side Unisub® Lid Topper. These toppers fit the 20oz, 30oz, and 40oz H2O tumbler lids.

• Do not submerge in water.
• After sublimating we recommend spraying with a polyacrylic spray to keep it water resistant on the back side.

Join our Facebook Group to stay up to date on new products and sales going on!

https://www.facebook.com/groups/blendedcustomsblanks

All whiteboard blanks sold by Blended Customs are laser cut from Unisub® brand whiteboard material in our shop located in Texas. All sublimation whiteboard is not equal to the quality of Unisub® brand whiteboard. It shows in your finished products!

Each piece has a protective film that will need to be removed prior to pressing.

We have found the below settings to yield the best results. All results may vary based on your particular press.

• Medium Pressure
• 400 degrees
• 120 seconds

Make sure the entire sublimation acrylic piece is covered in the sublimation paper. Do not make the sublimation paper smaller than the blank or it will press lines ("cracks") in the acrylic blank.